Quick answer
A pool compliance certificate in NSW confirms that a pool barrier met the rules when it was inspected, and it is valid for three years. You need one, or a certificate of non-compliance, to sell a home with a pool, and a certificate of compliance to lease one. Council inspections cost $150, plus $100 for a re-inspection.
Key takeaways
- A certificate of compliance is valid for 3 years.
- To sell, the contract needs a certificate of compliance or non-compliance. With non-compliance, the buyer has 90 days after settlement to fix the pool.
- To lease, you need a certificate of compliance. A non-compliance certificate isn’t enough.
- Council inspections cost $150, with $100 for one re-inspection. Private certifiers set their own fees.
- Gates that don’t self-close or self-latch are the most common reason pools fail.
What Is a Pool Compliance Certificate in NSW?
A pool compliance certificate, formally a certificate of compliance, is issued after a council inspector or authorised certifier inspects a pool barrier and finds it meets the rules under the Swimming Pools Act 1992. It is valid for three years. If the barrier fails, a certificate of non-compliance can be issued listing what needs fixing.
| Document | What it means | Used for |
|---|---|---|
| Certificate of compliance | The barrier complied when inspected | Selling or leasing; valid 3 years |
| Certificate of non-compliance | The barrier didn’t comply; defects listed | Selling only, not leasing |
| Registration certificate | The pool is on the NSW Swimming Pool Register | Needed with a sale or lease |
| Occupation certificate | Issued for a newly built pool | Can stand in for a compliance certificate when recent |
Scroll sideways to see the full table.
The certificate is a snapshot. It shows the barrier complied on the day of inspection, but the owner must keep it compliant every day after that. A gate that stops latching a month after the inspection is still a breach.
When Do You Need a Pool Compliance Certificate?
You need a pool certificate when you sell or lease a property with a pool or spa in NSW. Council may also inspect pools under its inspection program, or after a complaint. Owners who aren’t selling or leasing don’t need a certificate, but must keep the pool registered and the barrier compliant at all times.
- Selling: a certificate of compliance, a recent occupation certificate, or a certificate of non-compliance must be attached to the contract
- Leasing: a valid certificate of compliance or a recent occupation certificate
- Council inspections: councils run inspection programs and respond to complaints
- Everyone: the pool must be on the NSW Swimming Pool Register, with a CPR sign displayed
Because certificates last three years, many landlords time their inspection to cover several leases. If you’re planning to sell, get the inspection done before the property is listed, so any repairs don’t hold up the sale.
What Do You Need to Sell a Home With a Pool in NSW?
To sell a home with a pool in NSW, the contract of sale must include a certificate of compliance, a recent occupation certificate, or a certificate of non-compliance. If you sell with a non-compliance certificate, the buyer becomes responsible for fixing the barrier, and has 90 days after settlement to make it compliant.
Selling with a non-compliance certificate is legal, but buyers and their solicitors notice it. Some buyers ask for a price reduction to cover the repairs; others walk away. Fixing common faults before listing is usually cheaper than the discount, because most fixes cost a few hundred dollars.
Example: fixing before a sale
An older pool in Ambarvale fails its inspection on the gate and one gap under the fence. The owner fixes both before listing.
- Council inspection
- $150
- New self-closing hinges and latch
- $180 – $350
- Close the gap under one panel
- Quoted on site
- Council re-inspection
- $100
- Typical total before listing
- About $430 – $800 plus the gap fix
What Do You Need to Lease a Property With a Pool?
To lease a property with a pool or spa in NSW, the landlord needs a valid certificate of compliance, or a recent occupation certificate, before the lease starts. A certificate of non-compliance can’t be used for a lease. The pool must also be registered, and the barrier kept compliant throughout the tenancy.
Property managers in Campbelltown usually track certificate expiry dates, because a lease can’t be signed once the three years run out. If the pool fails, the repairs have to be done and a certificate of compliance issued before a new tenancy begins.
- Book the inspection several weeks before the certificate expires
- Fix any defects before the new tenant moves in
- Give tenants a copy of the certificate with the lease
- Ask tenants to report gate or fence problems straight away
Who Can Inspect a Pool and Issue a Certificate?
Pool barriers in NSW can be inspected, and certificates issued, by your local council or by a certifier who is authorised to inspect swimming pools. In Campbelltown, that means Campbelltown City Council or a private pool certifier. Both inspect against the same rules, but fees, availability and turnaround times differ.
| Council | Private certifier | |
|---|---|---|
| Fee | $150, plus $100 for one re-inspection | Set by the certifier |
| Availability | Depends on council bookings | Often faster to book |
| If the pool fails | Notice of defects and re-inspection | Notice of defects; council is told of non-compliance |
Scroll sideways to see the full table.
Check that any private certifier is authorised to inspect pools before you book. Pool fencing installers fix defects, but the inspection and certificate must come from council or an authorised certifier.
How Much Does a Pool Compliance Inspection Cost in NSW?
A council pool inspection in NSW costs $150, with an extra $100 if a re-inspection is needed after you fix defects. Private certifiers set their own fees, which are often higher but may come with quicker bookings. The bigger cost is usually any repair work needed before the pool passes.
| Item | Typical cost |
|---|---|
| Council inspection | $150 |
| Council re-inspection | $100 |
| Private certifier inspection | Set by the certifier |
| New gate hinges and latch | $180 – $350 |
| New self-closing aluminium gate | $350 – $600 |
| CPR sign | About $30 – $60 |
Fees can change, so check the current amount when you book. For a full pool fence replacement, see prices on our pool fencing and glass pool fencing pages.
What Happens at a Pool Inspection?
At a pool inspection, the certifier checks the pool is registered, then measures the barrier height and gaps, tests the gate from several positions, checks the latch height, looks for climbable objects in the non-climbable zone, checks doors and windows that open toward the pool, and confirms a CPR sign is displayed.
Book the inspection
With council or an authorised certifier, and pay the fee.
Registration check
The inspector confirms the pool is on the NSW Swimming Pool Register.
Barrier measurements
Height, gaps under and between panels, and rail spacing.
Gate test
Self-closing from fully open, half open and slightly open; self-latching every time.
Climbing aids
Pots, furniture, plants and fixtures within the non-climbable zone.
Outcome
A certificate of compliance, or a notice listing the defects to fix.
The barrier is checked against the standard that applies to your pool, which depends on when it was built. Our NSW pool fence rules guide explains every measurement.
What Are the Most Common Reasons a Pool Fails Inspection?
Most pools fail inspection because the gate doesn’t self-close or self-latch, there are climbable objects within 900mm of the top of the fence, the gap under the fence is wider than 100mm, the CPR sign is missing or faded, or the pool isn’t registered. Most of these are quick and cheap to fix.
| Failure | Fix | Guide cost |
|---|---|---|
| Gate doesn’t self-close or latch | Adjust or replace hinges and latch | $180 – $350 |
| Latch too low or reachable | Raise or shield the latch | Quoted on site |
| Pots, chairs or plants near the fence | Move or trim | Free |
| Pool pump or filter box against the fence | Relocate or enclose | Quoted on site |
| Gap under the fence over 100mm | Lower panels or add a plinth | Quoted on site |
| Missing or faded CPR sign | New sign | About $30 – $60 |
| Pool not registered | Register online | Free |
Scroll sideways to see the full table.
Boundary fences cause their own failures: a timber or COLORBOND fence used as part of the barrier may have rails or capping on the pool side within the top 900mm, or be under 1.8m high. These need a fence fix, not just tidying up.
How Do You Pass a Pool Inspection the First Time?
To pass first time, register the pool, test the gate from every position and fix it if it sticks, clear everything within 900mm of the top of the fence, measure the gap under the fence and the fence height in several places, replace a faded CPR sign, and check any windows or doors that open toward the pool.
Register the pool
Check it’s on the NSW Swimming Pool Register and the details are right.
Test the gate
From fully open, half open and slightly open. It must close and latch every time.
Clear the zone
Move pots, furniture, toys and barbecues away from the fence, and trim plants.
Measure
Fence at least 1200mm high and gaps no wider than 100mm, along the whole barrier.
Check the sign
A current CPR sign, clearly visible from the pool.
Fix before booking
Have a pool fencer fix any faults before the inspection, not after.
What Happens If Your Pool Fails the Inspection?
If your pool fails, the inspector gives you written notice of the defects. Once you fix them, you book a re-inspection, and a certificate of compliance is issued if the barrier now complies. If it isn’t fixed, a certificate of non-compliance may be issued and council is told, and council can direct you to fix the barrier.
A certificate of non-compliance doesn’t stop a sale, but it does stop a lease, and it puts the pool on council’s radar. Fixing the defects quickly is the cheapest and safest path. A pool fencing installer can usually fix gate hardware, gaps and loose panels in a single visit.
Keep the pool safe while you fix it
Until the defects are fixed, keep children out of the pool area and never leave the gate propped open. If the barrier is badly damaged, install temporary pool fencing.
Are Older Pools Inspected Against Today’s Rules?
Generally not. An older pool barrier in NSW is usually inspected against the Australian Standard that applied when the pool was built: AS 1926-1986 for pools built before 30 August 2008, AS 1926.1-2007 for pools built from 1 September 2008 to 30 April 2013, and AS 1926.1-2012 after that. Altering the barrier can bring in the current standard.
This matters in established Campbelltown suburbs, where many pools date from the 1980s and 1990s. An older barrier doesn’t have to be rebuilt to today’s standard to pass, but it must fully comply with its own standard and be in good repair. If you replace a large part of it, plan for the new work to meet AS 1926.1-2012.
Some very old pools, and pools on very small, very large or waterfront blocks built before 1 July 2010, were allowed to restrict access from the house instead of having a full fence. The inspector checks how your pool was approved. Our pool fence rules guide explains these exemptions.
Do Strata and Unit Pools Need a Compliance Certificate?
Generally, lots in strata or community schemes with more than two lots don’t need their own pool certificate to be sold or leased, because the shared pool is the owners corporation’s responsibility and is subject to council inspection. Smaller schemes, such as duplexes and two-lot strata, are generally treated like houses. Check with your strata manager.
The owners corporation must still keep a shared pool registered and its barrier compliant. If you own a townhouse or duplex with a pool, ask your conveyancer or property manager which rules apply before you list or lease, so you aren’t caught without the right certificate.
How Long Does a Pool Compliance Certificate Last?
A certificate of compliance in NSW is valid for three years from the date it is issued. After three years, a new inspection is needed before the property can be leased again, or for the certificate to be used in a sale. The owner must keep the barrier compliant for the whole period.
If the barrier is changed during those three years, for example a section of fence is replaced or a new gate is installed, make sure the new work complies with the rules that now apply. Altering a barrier can bring in the current standard, AS 1926.1-2012.
Frequently Asked Questions
Can I sell my house without a pool compliance certificate?
You can sell with a certificate of non-compliance instead of a certificate of compliance, but one of them, or a recent occupation certificate, must be attached to the contract. With a non-compliance certificate, the buyer must fix the barrier within 90 days after settlement.
Can I rent out a property with a pool without a certificate?
No. A property with a pool can’t be leased without a valid certificate of compliance or a recent occupation certificate. A certificate of non-compliance isn’t enough for a lease.
Do spas need a compliance certificate?
Yes, if the spa can hold 300mm or more of water. Spas are treated as swimming pools, so they must be registered and meet the barrier rules, which may allow a lockable, child-safe cover.
Does a compliance certificate mean my pool is safe?
It means the barrier met the rules on the day of inspection. Barriers reduce the risk, but they don’t replace supervision. Keep gates shut, check them monthly, and always watch children around water.
How long does it take to get a pool certificate?
It depends on booking times. If the pool passes, the certificate is usually issued soon after the inspection. If it fails, allow time for repairs and a re-inspection, which is why it pays to inspect well before a sale or lease.
Can my pool fencer issue the certificate?
No. The certificate must come from council or a certifier authorised to inspect pools. A pool fencing installer fixes the defects so the pool can pass the inspection.
Sources
- Swimming Pools Act 1992 (NSW) (opens in a new tab)
- NSW Swimming Pool Register (opens in a new tab)
- Pool fencing (Campbelltown City Council) (opens in a new tab)
- Swimming pool safety legislation (Burwood Council) (opens in a new tab)
- Swimming pool inspections and fees (Hilltops Council) (opens in a new tab)