Automatic sliding driveway gate with horizontal aluminium slats
Gates and automation

Driveway Gates & Automatic Gates Campbelltown

Swing, sliding and pedestrian gates installed across Campbelltown and Macarthur, built to match your fence and automated with quality motors, remotes, keypads and safety beams. Automatic sliding gates from $3,550, with solar options where mains power is hard to reach.

  • Automatic sliding gates from $3,550
  • Safety beams and battery backup
  • Solar or mains power

Gates and automation in Campbelltown at a glance

Pedestrian gates
From $350
Driveway gates
From $900 (manual)
Automatic sliding
From $3,550 complete
Motor kits
$1,800 – $3,800 installed
Power
Mains or solar
Materials
Colorbond, timber, aluminium
What we install

What Gates Do We Install in Campbelltown?

We install three kinds of gate across Campbelltown: double swing driveway gates, sliding driveway gates that run along the fence line, and single pedestrian and side gates. Every gate can be built in COLORBOND steel, timber or aluminium slat to match your fence, and driveway gates can be automated.

Swing driveway gates

from $900

A pair of leaves that swing inward. Best for level driveways with clear space inside the gate.

Sliding driveway gates

from $1,500

One leaf that rolls along a track beside the fence. Best for sloping, short or tight driveways.

Pedestrian and side gates

from $350

Single gates for paths, bins and side access, with latches, drop bolts or locks.

Prices

How Much Do Driveway Gates and Automatic Gates Cost in Campbelltown?

Driveway gates in Campbelltown cost $900 to $2,400 for manual double swing gates and $1,500 to $3,200 for a manual sliding gate, installed, including GST. Automating a sliding gate adds $1,800 to $3,200, so a complete automatic sliding gate with safety beams starts from about $3,550.

Gates, supplied and installed (guide prices incl. GST)
GateInstalled priceBest for
Pedestrian or side gate$350 – $900Paths, bins and side access
Double swing driveway gates$900 – $2,400Level driveways with room to swing
Manual sliding driveway gate$1,500 – $3,200Sloping or tight driveways

Scroll sideways to see the full table.

Automation and access (guide prices incl. GST)
ItemPrice
Sliding gate motor kit, installed$1,800 – $3,200 incl. 2 remotes
Double swing gate motor kit, installed$2,200 – $3,800 incl. 2 remotes
Solar power kit (instead of mains)+ $600 – $1,200
Safety beams (photo-electric)$250 – $450
Keypad or video intercom$250 – $1,500
Extra remotes$60 – $120 each

Worked example: an automatic sliding gate

A typical Campbelltown driveway needs a gate about 4 metres wide. Here is a complete automatic sliding gate in aluminium slat or COLORBOND, with a motor, two remotes and safety beams.

4m sliding gate and track
$1,500 – $3,200
Motor kit with 2 remotes
$1,800 – $3,200
Safety beams
$250 – $450
Total, installed
$3,550 – $6,850

What changes the price

  • Width and weight: wider, heavier gates need bigger motors
  • Material: aluminium slat costs more than COLORBOND or timber
  • Power: mains power run by an electrician, or a solar kit
  • Ground: sliding gates need a level, concreted track
  • Access: keypads, intercoms and phone control are optional extras

Not included unless quoted

  • electrical work to bring mains power to the gate, done by a licensed electrician
  • new driveway concrete or kerb work
  • removing an old gate or fence, from $20 per metre

Guide prices for Campbelltown and the Macarthur region, October 2026. Your written quote after the free on-site measure is the firm price.

Want to open your gate from the car?

Book a free on-site measure. You get a fixed, itemised written quote, usually within 24 hours.

Choosing

Swing or Sliding: Which Driveway Gate Suits Your Block?

A swing gate suits a level driveway with clear space inside for the leaves to open, and it costs a little less to automate. A sliding gate suits sloping, short or tight driveways, because it rolls along the fence instead of swinging, but it needs a run-back about as long as the opening.

Seen from above: swing gates need clear space inside the property for the leaves to swing through, while a sliding gate needs room along the fence line to slide back into. street Swing: needs clear space inside driveway street Sliding: needs room along the fence openingslides back
Seen from above: the space each gate type needs.
Swing vs sliding driveway gates
SwingSliding
Space neededClear arc inside the gateFence-line run-back
Sloping drivewayCan’t open uphillWorks well
Gate price (manual)$900 – $2,400$1,500 – $3,200
Motor kit, installed$2,200 – $3,800$1,800 – $3,200
Windy sitesLeaves can catch windMore stable

Scroll sideways to see the full table.

Automation

What Does Gate Automation Include?

Gate automation includes an electric motor, a control board, two remotes, and safety features that stop or reverse the gate if something is in the way. Most kits also include battery backup for blackouts and a manual release key. Keypads, intercoms and phone control can be added.

Motor and control board

Sized to the gate’s weight and width. Established brands in Australia include BFT, FAAC and Centurion. Your quote names the motor.

Safety

Obstacle detection and photo-electric safety beams stop or reverse the gate. Gate drives are covered by AS/NZS 60335.2.103.

Battery backup

Keeps the gate working through a blackout, with a manual release key as a final fallback.

Remotes and access

Two remotes as standard, plus optional keypads, video intercoms and phone-app control.

Power

Solar or Mains Power for an Automatic Gate?

Mains power is best when the gate is close to the house and a power run is easy. It needs a licensed electrician to bring power to the gate. A solar kit, from $600 to $1,200 extra, avoids trenching and cabling, which suits long driveways and acreage blocks in Appin, Wedderburn, Gilead and Kentlyn.

  • Mains: reliable for busy gates, with power run underground by a licensed electrician
  • Solar: a panel charges the battery, with no trenching across the driveway or lawn
  • Both: battery backup keeps the gate running in a blackout

Very busy gates may need extra solar panels or batteries. The installer sizes the kit to how often you use the gate.

Retrofits

Can You Automate My Existing Gate?

Often, yes. An existing swing or sliding gate can be automated if its frame is strong and square, its hinges or wheels are in good condition, and it moves freely by hand. Sliding gates need a level, solid track. The installer checks all of this at the free measure.

If the gate sags, drags or binds, it is repaired or replaced first, because a motor will only make a struggling gate fail faster. Automating a sound gate costs the motor kit price, from $1,800 for a sliding gate.

Materials

Which Materials Can Gates Be Made From?

Gates are built to match your fence: COLORBOND steel in any of 15 colours, timber palings on a braced frame, or powder-coated aluminium slat or tubular. Matching the gate to the fence makes the whole front boundary look like one design. Aluminium is the lightest, which suits automation.

COLORBOND gates

Steel-framed and clad with the same sheets as your fence. See our Colorbond fencing page.

Timber gates

Palings on a braced frame, matched to your fence. See our timber fencing page.

Aluminium slat gates

Light, rust-proof and easy to automate. See our aluminium and slat fencing page.

Gate repairs

Do You Repair Gates and Gate Motors?

Yes. Sagging, dragging and non-latching gates are rehung, re-braced or fitted with new hinges and latches for $180 to $450. For automatic gates, faulty remotes, safety beams, tracks and motors are diagnosed on site and quoted before any work starts. Many faults are fixed in one visit.

  • gates that sag, drag on the ground or won’t latch
  • sliding gates jumping the track or running rough
  • remotes that have stopped working, and remotes that need reprogramming
  • gates that stop, reverse or won’t close because of a beam or sensor fault

Fence damage around the gate? See our fence repairs page.

Safety

Are Automatic Gates Safe for Kids and Pets?

Yes, when they are installed and set up correctly. Automatic gates should stop or reverse when they meet resistance, safety beams should stop them closing on a person, pet or car, and the motor’s force should be set as low as the gate allows. Gate drives are covered by AS/NZS 60335.2.103.

  • safety beams across the opening are strongly recommended for every automatic gate
  • keep remotes away from children, and never let children play near a moving gate
  • test the safety beams and auto-reverse every few months
  • a driveway gate is not a pool barrier. Pool gates have their own rules
Booking with us

What Do You Get When You Book a Gate With Us?

Every gate booked through Starlit Fencing Campbelltown starts with a free on-site measure and a fixed, itemised written quote, usually within 24 hours. The gate is built to match your fence, the motor is sized to the gate, and safety features and remotes are set up and tested with you before handover.

Free on-site measure

The opening, slope, run-back space and power options are checked before you get a price.

Fixed, itemised quote

Gate, motor, beams, remotes and extras are listed separately, with no surprises.

Matched to your fence

COLORBOND, timber or aluminium, in the same colour and style as the fence.

Licensed installer

Ask for the NSW licence number and check it on the NSW Government licence register.

Tested at handover

Beams, auto-reverse and every remote are tested with you before the installer leaves.

One point of contact

We follow up after the job to make sure everything was done as quoted.

Installation

How Is an Automatic Gate Installed?

An automatic gate is installed in five steps: measure the opening and choose swing or sliding, set the posts and track, hang the gate, fit and wire the motor, beams and remotes, then test the safety features with you. Most automatic gates take one to two days, plus any electrical work.

  1. Measure and plan

    The opening, slope, run-back space and power options are checked, and the gate type is chosen.

  2. Posts and track

    Posts are set in concrete. Sliding gates get a level, concreted track.

  3. Hang the gate

    The gate is hung or set on its track and adjusted to move freely by hand.

  4. Fit automation

    The motor, control board, beams and remotes are fitted and connected to power or solar.

  5. Test and hand over

    Limits, force, beams and auto-reverse are set and tested, and you are shown the manual release.

Service area

Where Do We Install Gates and Automation?

We arrange gate installation and automation across the Campbelltown local government area and the wider Macarthur region, from suburban driveways in Glen Alpine, Mount Annan and Gregory Hills to acreage entrances in Kentlyn, Wedderburn, Gilead, Menangle Park and Appin, where solar gates are especially popular.

  • Campbelltown
  • Glen Alpine
  • Mount Annan
  • Harrington Park
  • Gregory Hills
  • Oran Park
  • Narellan
  • Camden
  • Leumeah
  • Bradbury
  • Ingleburn
  • Minto
  • Glenfield
  • Eagle Vale
  • St Helens Park
  • Rosemeadow
  • Kentlyn
  • Menangle Park
  • Denham Court
  • Wedderburn
  • Gilead
  • Appin

Don’t see your suburb? See all 48 suburbs on our service areas page, or call to check.

Gate questions

Gates and Automation FAQs

Quick answers to the gate questions Campbelltown homeowners ask before they book: blackouts, phone control, remotes, servicing, council approval and adding a gate to an existing fence. For general questions, see our full fencing FAQs.

What happens to an automatic gate in a blackout?

Most gate motor kits include battery backup, which keeps the gate opening and closing for a number of cycles without mains power. If the battery runs flat, a manual release key lets you unlock the motor and move the gate by hand.

Can I open my gate from my phone?

Yes, with an optional app or smart module. Phone control lets you open the gate for visitors or deliveries from anywhere. Keypads and video intercoms are other ways to let people in without handing out remotes.

How many remotes come with an automatic gate?

Two remotes are standard with most motor kits. Extra remotes cost $60 to $120 each, and new remotes can be programmed to an existing gate if one is lost.

Do automatic gates need servicing?

A quick check once a year keeps them reliable: clean the track or hinges, check the gate still moves freely by hand, and test the safety beams and auto-reverse. Batteries in backup systems usually need replacing every few years.

Do I need council approval for a driveway gate?

A gate in a front fence up to 1.2m high is usually exempt development in NSW, as long as it doesn’t open outward over the footpath or road. Taller front fences and gates generally need approval from Campbelltown City Council.

Can a gate be added to my existing fence?

Yes. A section of fence can be taken out and new gate posts set in concrete, with the gate built to match the fence. This is common for adding side access for bins, a trailer or a boat.

Free, no obligation

Get a Free Gate Quote in Campbelltown

Send the form and we call back the same working day to book your free on-site measure. Photos help us quote faster — attach one if you have it.

  1. 1
    You send the form

    Takes about 40 seconds.

  2. 2
    We call back same working day

    To book a measure that suits you.

  3. 3
    Fixed quote in 24 hours

    Itemised, in writing. The price does not move.

Rather talk it through?

Call 0432 666 474

Request your free measure

Fields marked * are required.

Mobile or landline — whichever suits.
A rough pace-out is fine.
Optional. Speeds the quote up considerably.

We quote free, and no obligation follows it. We pass your details to one licensed local fencing contractor to quote your job, and never sell them. Read our privacy policy.