Brushwood fence with a rolled top behind a garden bed
Brushwood fencing

Brushwood Fencing Campbelltown

Natural brushwood fences for gardens, courtyards and pool areas across Campbelltown and Macarthur. Dense panels or hand-thatched brush on galvanised steel posts, with roll-top capping, from $160 per metre installed.

  • Brushwood from $160/m
  • Full privacy, no gaps
  • Free on-site measure

Brushwood fencing in Campbelltown at a glance

Installed price
From $160 per metre (1.8m)
Made from
Broombush (Melaleuca uncinata)
Builds
Panels or hand-thatched
Posts
Galvanised steel in concrete
Typical life
15 to 25 years with care
Bush fire prone land
Not suitable
What we install

What Brushwood Fences Do We Install in Campbelltown?

We install two kinds of brushwood fence around Campbelltown: prefabricated brushwood panels fixed between galvanised steel posts, and hand-thatched brushwood packed on site between tensioned wires. Both are 1.8m high as standard, finished with a rolled brush top or a timber or steel capping, with matching brushwood gates.

Brushwood panels

from $160/m

Factory-made panels, about 45 to 50mm thick, wired tight and fixed between steel posts. The quickest and most economical brushwood fence.

Hand-thatched brushwood

from $230/m

Brush is packed by hand between wires strung post to post, so the posts disappear and the fence can follow curves and slopes.

Brushwood gates

from $650 each

Brush set in a welded steel frame, hung on a steel post, so the gate matches the fence without sagging.

What is brushwood fencing made of?

Brushwood fencing is made from broombush (Melaleuca uncinata), a native Australian shrub whose thin, straight stems are cut, bundled and bound with galvanised wire. Packed tightly, the stems make a dense, textured fence with no gaps, which suits gardens better than a flat steel or timber face.

  • Posts: galvanised steel, set in concrete, so nothing rots in the ground
  • Brush: panels or hand-packed stems, wired tight on both faces
  • Capping: a rolled brush top, or timber or steel capping, to shed rain
  • Base: kept just clear of soil and mulch, so the stems stay dry
Close view of a brushwood fence with a rolled brush top and galvanised wire
A rolled brush top sheds rain and finishes the fence.
Prices

How Much Does Brushwood Fencing Cost in Campbelltown?

A 1.8m brushwood fence in Campbelltown costs $160 to $240 per metre installed for prefabricated panels on steel posts, and $230 to $330 per metre for hand-thatched brushwood, including GST. Roll-top capping adds $25 to $45 per metre. Gates and removal of the old fence are priced separately.

Brushwood fencing, supplied and installed, per metre (guide prices incl. GST)
FenceInstalled priceBest for
Brushwood panels, 1.8m, on steel posts$160 – $240Most side and rear boundaries
Hand-thatched brushwood, 1.8m$230 – $330Feature fences and curved lines
Brushwood panels, 1.5m$140 – $210Courtyards and garden screens
Brushwood cladding on a sound fence or frame$110 – $180Hiding an old fence or wall

Scroll sideways to see the full table.

Capping, gates and extras (guide prices incl. GST)
ItemPrice
Roll-top brush capping$25 – $45 per metre
Timber or steel capping$15 – $30 per metre
Brushwood gate in a steel frame$650 – $1,200 each
Remove and dispose of the old fence$20 – $40 per metre
Re-cap or re-wire an existing brush fenceQuoted on site

Worked example: a 15m back fence behind a garden

A 15 metre rear boundary gets new 1.8m brushwood panels on steel posts with a rolled brush top, after the old paling fence is taken away. Here is a typical cost.

15m brushwood panels, 1.8m
$2,400 – $3,600
15m roll-top capping
$375 – $675
Remove the old fence
$300 – $600
Total, installed
$3,075 – $4,875

What changes the price

  • Build: hand-thatching takes far longer than fixing panels
  • Height: 1.5m screens cost less than 1.8m fences
  • Capping: a rolled brush top costs more than timber or steel
  • Slope and curves: stepped panels or hand-packing add labour
  • Access: narrow side paths and garden beds slow the job

What the price includes

  • galvanised steel posts set in concrete
  • brushwood panels or hand-packed brush, wired tight
  • trimming the top and both faces
  • installation on a clear, level site
  • removal of offcuts and packaging

Guide prices for Campbelltown and the Macarthur region, November 2026. Your written quote after the free on-site measure is the firm price.

Ready to price your brushwood fence?

Book a free on-site measure. You get a fixed, itemised written quote, usually within 24 hours.

Choosing

Is Brushwood Better Than Colorbond or Timber?

Brushwood is the better choice when looks matter most: it gives full privacy with a soft, natural face that suits gardens and softens noise. Colorbond and timber paling cost about half as much per metre and need less care, and Colorbond is non-combustible, so it suits bush fire prone land, where brushwood doesn’t.

Brushwood compared with Colorbond and timber paling fences (1.8m)
BrushwoodColorbond steelTimber paling
Installed price$160 – $330 /m$92 – $135 /m$92 – $200 /m
PrivacyFull, no gapsFullFull when lapped
NoiseAbsorbs and softensReflectsBlocks some
Typical life15 to 25 yearsDecades; steel warranty up to 15 years10 to 20 years or more
Bush fire prone landNot suitableSuitable, non-combustibleHardwood only, with limits
UpkeepKeep dry at the base, re-cap in timeHose downStain or oil every 3 to 5 years

Scroll sideways to see the full table.

See prices and options on our Colorbond fencing and timber fencing pages.

Bush fire prone land

Can You Use Brushwood on Bush Fire Prone Land?

No. Brushwood is combustible, and in NSW a new fence on bush fire prone land must be non-combustible or hardwood to be built without approval. Parts of Kentlyn, Wedderburn, Gilead, Appin and the bushland edges of other suburbs are bush fire prone, so check your property before you choose brushwood.

  • Check first: search your address on the NSW Rural Fire Service bush fire prone land tool, or ask Campbelltown City Council
  • Near the house: on any block, keep brushwood away from windows, decks, gas bottles and barbecues
  • The alternative: a COLORBOND steel fence is non-combustible, from $92 per metre

If your block is bush fire prone, we will say so at the measure and quote a fence that suits it.

Lifespan and care

How Long Does a Brushwood Fence Last?

A well-built brushwood fence typically lasts 15 to 25 years. It lasts longest on galvanised steel posts, with a capping that sheds rain and a base kept clear of soil, mulch and sprinklers. The capping usually wears first, and can be replaced without rebuilding the fence.

Keep the base dry

Hold soil, mulch and garden beds back from the bottom of the brush, and aim sprinklers away from it.

Look after the capping

The top takes the weather. A new rolled top or capping after some years protects the brush below.

Trim, don’t climb

Loose strands can be trimmed or re-wired. Keep creepers, ladders and children off the fence.

New brushwood is a warm brown. It weathers to a soft silver-grey over the first few years, which is normal and doesn’t affect its strength.

Noise and privacy

Does a Brushwood Fence Reduce Noise?

It helps. A brushwood fence is thick, dense and rough-faced, so it absorbs and scatters sound instead of bouncing it back like a flat steel sheet. It takes the edge off traffic, pool pumps and neighbours’ voices. It is not a rated acoustic barrier, so it won’t silence a busy road.

  • Privacy: tightly packed stems leave no gaps to see through
  • Height matters most: a 1.8m fence that blocks the line of sight to the noise does the most
  • No gaps underneath: sound leaks under a fence, so the base should sit close to the ground without touching soil
Booking with us

What Do You Get When You Book Brushwood Fencing With Us?

Every brushwood fence booked through Starlit Fencing Campbelltown starts with a free on-site measure and a fixed, itemised written quote, usually within 24 hours. A licensed local installer builds it on galvanised steel posts, the bush fire status of your block is checked first, and the site is left clean.

Free on-site measure

Length, slope, garden beds and access are checked before you get a price.

Fixed, itemised quote

Fence, capping, gates and removal are listed separately, ready for a fencing notice.

Bush fire check first

If brushwood doesn’t suit your block, you hear it before you pay for anything.

Licensed installer

Ask for the NSW licence number and check it on the NSW Government licence register.

Steel posts as standard

Galvanised posts in concrete, so the frame outlasts the brush.

One point of contact

We follow up after the job to make sure everything was done as quoted.

Installation

How Is a Brushwood Fence Installed?

A brushwood fence is installed in five steps: measure and quote, remove the old fence, set galvanised steel posts in concrete, fix the panels or hand-pack the brush between wires, then cap and trim it. A typical 15 to 20 metre panel fence takes one to two days, and hand-thatching takes longer.

  1. Measure and quote

    The line, height and capping are agreed on site, then a written quote is sent.

  2. Clear the line

    The old fence is removed and taken away, and garden beds are protected.

  3. Set the posts

    Galvanised steel posts go into concrete footings and are left to set.

  4. Fix the brush

    Panels are fixed post to post, or brush is hand-packed between tensioned wires.

  5. Cap and trim

    The top is capped, both faces are trimmed, and the site is cleaned up.

Service area

Where Do We Install Brushwood Fencing?

We arrange brushwood fencing across Campbelltown and the Macarthur region, including Glen Alpine, Bradbury, Ruse, Leumeah, Ingleburn, Glenfield and Macquarie Links, and nearby Narellan, Mount Annan, Harrington Park, Gregory Hills, Oran Park and Camden.

  • Campbelltown
  • Glen Alpine
  • Bradbury
  • Ruse
  • Leumeah
  • Ingleburn
  • Glenfield
  • Macquarie Fields
  • Macquarie Links
  • Denham Court
  • Narellan
  • Mount Annan
  • Currans Hill
  • Harrington Park
  • Gregory Hills
  • Oran Park
  • Camden
  • Elderslie

Don’t see your suburb? See all 48 suburbs on our service areas page, or call to check.

Brushwood questions

Brushwood Fencing FAQs

Quick answers to the brushwood fencing questions Campbelltown homeowners ask before they book: pool fences, repairs and re-capping, cladding an existing fence, shared boundaries, heights and colour. For general questions, see our full fencing FAQs.

Can brushwood be used as a pool fence?

Only if it meets the pool barrier standard, AS 1926.1. A boundary fence used as a pool barrier must be at least 1.8m high, in good condition and without gaps or footholds. Ask an accredited certifier before relying on brushwood, and see our pool fencing page for the usual options.

Can you repair or re-cap an old brushwood fence?

Often, yes. Loose sections can be re-wired, thin patches packed with new brush, and a worn top replaced with a new rolled top or capping. If the brush has rotted along the base or the posts have failed, replacing that section costs less in the long run.

Can brushwood go over my existing fence?

Yes, if the fence or frame behind it is sound. Brushwood panels can be fixed to a solid timber or steel fence as cladding, from $110 to $180 per metre. The posts must be strong enough for the extra weight and wind load, which is checked at the measure.

Who pays if I want brushwood on a shared boundary?

Under the Dividing Fences Act 1991 (NSW), neighbours usually share the cost of a sufficient dividing fence, which is generally a standard paling or steel fence. If you want brushwood and your neighbour doesn’t, you usually pay the difference. The itemised quote shows both figures.

How high can a brushwood fence be without council approval?

In most residential zones in NSW, up to 1.8m on side and rear boundaries and 1.2m at the front, the same as other fences. The exemption doesn’t cover brushwood on bush fire prone land, and heritage areas have their own rules.

Will a brushwood fence change colour?

Yes. New brushwood is a warm reddish brown and weathers to silver-grey over the first few years, like unsealed timber. The change is on the surface only. Shaded, damp sections may darken, which is a sign to clear plants and soil away from the base.

Free, no obligation

Get a Free Brushwood Fencing Quote in Campbelltown

Send the form and we call back the same working day to book your free on-site measure. Photos help us quote faster — attach one if you have it.

  1. 1
    You send the form

    Takes about 40 seconds.

  2. 2
    We call back same working day

    To book a measure that suits you.

  3. 3
    Fixed quote in 24 hours

    Itemised, in writing. The price does not move.

Rather talk it through?

Call 0432 666 474

Request your free measure

Fields marked * are required.

Mobile or landline — whichever suits.
A rough pace-out is fine.
Optional. Speeds the quote up considerably.

We quote free, and no obligation follows it. We pass your details to one licensed local fencing contractor to quote your job, and never sell them. Read our privacy policy.