
Swing, sliding and pedestrian gates installed across Campbelltown and Macarthur, built to match your fence and automated with quality motors, remotes, keypads and safety beams. Automatic sliding gates from $3,550, with solar options where mains power is hard to reach.
We install three kinds of gate across Campbelltown: double swing driveway gates, sliding driveway gates that run along the fence line, and single pedestrian and side gates. Every gate can be built in COLORBOND steel, timber or aluminium slat to match your fence, and driveway gates can be automated.
A pair of leaves that swing inward. Best for level driveways with clear space inside the gate.
One leaf that rolls along a track beside the fence. Best for sloping, short or tight driveways.
Single gates for paths, bins and side access, with latches, drop bolts or locks.
Driveway gates in Campbelltown cost $900 to $2,400 for manual double swing gates and $1,500 to $3,200 for a manual sliding gate, installed, including GST. Automating a sliding gate adds $1,800 to $3,200, so a complete automatic sliding gate with safety beams starts from about $3,550.
| Gate | Installed price | Best for |
|---|---|---|
| Pedestrian or side gate | $350 – $900 | Paths, bins and side access |
| Double swing driveway gates | $900 – $2,400 | Level driveways with room to swing |
| Manual sliding driveway gate | $1,500 – $3,200 | Sloping or tight driveways |
Scroll sideways to see the full table.
| Item | Price |
|---|---|
| Sliding gate motor kit, installed | $1,800 – $3,200 incl. 2 remotes |
| Double swing gate motor kit, installed | $2,200 – $3,800 incl. 2 remotes |
| Solar power kit (instead of mains) | + $600 – $1,200 |
| Safety beams (photo-electric) | $250 – $450 |
| Keypad or video intercom | $250 – $1,500 |
| Extra remotes | $60 – $120 each |
A typical Campbelltown driveway needs a gate about 4 metres wide. Here is a complete automatic sliding gate in aluminium slat or COLORBOND, with a motor, two remotes and safety beams.
Guide prices for Campbelltown and the Macarthur region, October 2026. Your written quote after the free on-site measure is the firm price.
Want to open your gate from the car?
Book a free on-site measure. You get a fixed, itemised written quote, usually within 24 hours.
A swing gate suits a level driveway with clear space inside for the leaves to open, and it costs a little less to automate. A sliding gate suits sloping, short or tight driveways, because it rolls along the fence instead of swinging, but it needs a run-back about as long as the opening.
| Swing | Sliding | |
|---|---|---|
| Space needed | Clear arc inside the gate | Fence-line run-back |
| Sloping driveway | Can’t open uphill | Works well |
| Gate price (manual) | $900 – $2,400 | $1,500 – $3,200 |
| Motor kit, installed | $2,200 – $3,800 | $1,800 – $3,200 |
| Windy sites | Leaves can catch wind | More stable |
Scroll sideways to see the full table.
Gate automation includes an electric motor, a control board, two remotes, and safety features that stop or reverse the gate if something is in the way. Most kits also include battery backup for blackouts and a manual release key. Keypads, intercoms and phone control can be added.
Sized to the gate’s weight and width. Established brands in Australia include BFT, FAAC and Centurion. Your quote names the motor.
Obstacle detection and photo-electric safety beams stop or reverse the gate. Gate drives are covered by AS/NZS 60335.2.103.
Keeps the gate working through a blackout, with a manual release key as a final fallback.
Two remotes as standard, plus optional keypads, video intercoms and phone-app control.
Mains power is best when the gate is close to the house and a power run is easy. It needs a licensed electrician to bring power to the gate. A solar kit, from $600 to $1,200 extra, avoids trenching and cabling, which suits long driveways and acreage blocks in Appin, Wedderburn, Gilead and Kentlyn.
Very busy gates may need extra solar panels or batteries. The installer sizes the kit to how often you use the gate.
Often, yes. An existing swing or sliding gate can be automated if its frame is strong and square, its hinges or wheels are in good condition, and it moves freely by hand. Sliding gates need a level, solid track. The installer checks all of this at the free measure.
If the gate sags, drags or binds, it is repaired or replaced first, because a motor will only make a struggling gate fail faster. Automating a sound gate costs the motor kit price, from $1,800 for a sliding gate.
Gates are built to match your fence: COLORBOND steel in any of 15 colours, timber palings on a braced frame, or powder-coated aluminium slat or tubular. Matching the gate to the fence makes the whole front boundary look like one design. Aluminium is the lightest, which suits automation.
Steel-framed and clad with the same sheets as your fence. See our Colorbond fencing page.
Palings on a braced frame, matched to your fence. See our timber fencing page.
Light, rust-proof and easy to automate. See our aluminium and slat fencing page.
Yes. Sagging, dragging and non-latching gates are rehung, re-braced or fitted with new hinges and latches for $180 to $450. For automatic gates, faulty remotes, safety beams, tracks and motors are diagnosed on site and quoted before any work starts. Many faults are fixed in one visit.
Fence damage around the gate? See our fence repairs page.
Yes, when they are installed and set up correctly. Automatic gates should stop or reverse when they meet resistance, safety beams should stop them closing on a person, pet or car, and the motor’s force should be set as low as the gate allows. Gate drives are covered by AS/NZS 60335.2.103.
Every gate booked through Starlit Fencing Campbelltown starts with a free on-site measure and a fixed, itemised written quote, usually within 24 hours. The gate is built to match your fence, the motor is sized to the gate, and safety features and remotes are set up and tested with you before handover.
The opening, slope, run-back space and power options are checked before you get a price.
Gate, motor, beams, remotes and extras are listed separately, with no surprises.
COLORBOND, timber or aluminium, in the same colour and style as the fence.
Ask for the NSW licence number and check it on the NSW Government licence register.
Beams, auto-reverse and every remote are tested with you before the installer leaves.
We follow up after the job to make sure everything was done as quoted.
An automatic gate is installed in five steps: measure the opening and choose swing or sliding, set the posts and track, hang the gate, fit and wire the motor, beams and remotes, then test the safety features with you. Most automatic gates take one to two days, plus any electrical work.
The opening, slope, run-back space and power options are checked, and the gate type is chosen.
Posts are set in concrete. Sliding gates get a level, concreted track.
The gate is hung or set on its track and adjusted to move freely by hand.
The motor, control board, beams and remotes are fitted and connected to power or solar.
Limits, force, beams and auto-reverse are set and tested, and you are shown the manual release.
We arrange gate installation and automation across the Campbelltown local government area and the wider Macarthur region, from suburban driveways in Glen Alpine, Mount Annan and Gregory Hills to acreage entrances in Kentlyn, Wedderburn, Gilead, Menangle Park and Appin, where solar gates are especially popular.
Don’t see your suburb? See all 48 suburbs on our service areas page, or call to check.
Quick answers to the gate questions Campbelltown homeowners ask before they book: blackouts, phone control, remotes, servicing, council approval and adding a gate to an existing fence. For general questions, see our full fencing FAQs.
Most gate motor kits include battery backup, which keeps the gate opening and closing for a number of cycles without mains power. If the battery runs flat, a manual release key lets you unlock the motor and move the gate by hand.
Yes, with an optional app or smart module. Phone control lets you open the gate for visitors or deliveries from anywhere. Keypads and video intercoms are other ways to let people in without handing out remotes.
Two remotes are standard with most motor kits. Extra remotes cost $60 to $120 each, and new remotes can be programmed to an existing gate if one is lost.
A quick check once a year keeps them reliable: clean the track or hinges, check the gate still moves freely by hand, and test the safety beams and auto-reverse. Batteries in backup systems usually need replacing every few years.
A gate in a front fence up to 1.2m high is usually exempt development in NSW, as long as it doesn’t open outward over the footpath or road. Taller front fences and gates generally need approval from Campbelltown City Council.
Yes. A section of fence can be taken out and new gate posts set in concrete, with the gate built to match the fence. This is common for adding side access for bins, a trailer or a boat.
Send the form and we call back the same working day to book your free on-site measure. Photos help us quote faster — attach one if you have it.
Takes about 40 seconds.
To book a measure that suits you.
Itemised, in writing. The price does not move.
Rather talk it through?
Call 0432 666 474Licensed fencing contractors installing Colorbond, timber, pool, glass and aluminium fencing across Campbelltown and the Macarthur region.
Campbelltown, NSW 2560
contact@starlitfencingcampbelltown.com.au
+61 432 666 474
Copyright 2026, Starlit Fencing Campbelltown. All Rights Reserved.